Your Cart is Empty


Golden Pecan Herringbone Chevron Wood Solid Vinyl on Paste the Wall Wallpaper

•Roll Size  33 ft = 1 Double Roll   (10 m)

•Width 20.5"  (52.07 cm)

•Coverage 56 Square ft. total  (5.37 m²)

•Pattern Repeat 12.5"  (31.75 cm)

•Attributes Washable, Strippable, Paste the Wall

This paper is printed on a Paste the Wall product. Manufacturers of paste the wall wallpaper have the novice home decorator in mind. The width of each is 1.5".

Step 1 – Prepare the Wall Just like any other wallpaper job, you need to make sure your wall is nice and sparkling clean before you get started, otherwise the adhesive will be less effective. In a bucket, mix some warm water with a small amount of vinegar. Put on your work gloves and wash the walls with the vinegar solution and a sponge to remove any dirt and residues, then let dry.

Step 2 – Start Pasting the Wall Usually, a special adhesive is supplied with your paste the wall wallpaper kit. Sometimes the paste will need to be mixed or prepared; refer to the manufacturer’s directions, and do as instructed. Now that your walls are clean and dry, use a paint roller to start applying the adhesive directly to the wall in a thin, even layer. Some suggest that you apply the paste just a little bit at a time (for example, the amount you need for one strip) as opposed to over the entire wall; otherwise, it might start drying before you’re ready!

Step 3 – Apply the Wallpaper Take your first strip of wallpaper. Begin at the topmost, left-hand corner, and align the strip so that it’s perfectly straight. Stretch out roughly 12 inches of paper, and affix it to the top of the wall. Slowly unroll the paper, using a wallpaper brush to smooth it down on the way, thus preventing air bubbles and wrinkles. Pros suggest you unroll the wallpaper about a foot at a time. Trim any excess left over at the bottom, and then repeat for the rest of the wall.